Air Conditioner Maintenance

 Check the outside condensing unit
 The first thing is to make sure the condensing unit ( located outside ) is not covered augmentation. The unit needs to draw air into the mold in order to arctic and circulate inside, but the process is hindered if it cannot job in enough appearance air. Frequent homeowners ignore they had temporarily stacked lawn furniture, bags of leaves and lawn clippings around their unit over the winter only to find it won ' t gelid in the summer.

 Some people intentionally cover their condenser to protect veritable from the elements during the winter, but these units require no refuge seeing they are designed to be outside.

 Run your air conditioner before regular use
 Run your air conditioner for a few minutes before you actually need legitimate, in late spring or cardinal summer. If you wait until the first warm day then discover it isn ' t working, you ' ll find yourself on a waiting list, sizzling for days before an air conditioning professional can come to conserve it.

 Change the air conditioner ' s filters regularly
 Dirty filters restrict air tear, reduce efficiency and worst case, can cause the evaporator to harden increasing. Disposable fiberglass filters should be replaced easily. Electrostatic or electronic filters require to be washed frequently.

 Check the approach panels
 Be sure all gate panels are secure, with all the screws in place.

 Check for obstructions
 Untroublesome obvious obstructions, such in that daily and leaves, from around the exterior of the unit.

 Set the correct mode
 Be sure the thermostat is set in the cooling mode. Just setting the dial below room temperature leave not activate the air conditioner if it is acknowledge in the heat arrangement.

 Never point water to clean your air conditioning system
 A thoroughly cleaned air conditioning unit will operate at top efficiency. However, homeowners are strongly discouraged from cleaning firm themselves by using a saturate and water because of the honest risk of electrical shock and possible shorting of electrical components.